Tony.....
I use the same connector but not flooded coax.
I use the QS coax from Lowes and after removing the outer braid and foil....the
connector goes on nicely.
But.....your flooded cable o/d could be too large for that connector.
The Lowes RG-6QS o/d coax is .277.
See the Belden site for connector specs.
73
David Harmon
K6XYZ
Sperry, OK
-----Original Message-----
From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Tony K1AMF
Sent: Monday, November 17, 2014 8:44 AM
To: topband@contesting.com
Subject: Topband: Help installing compression connectors
Anyone have any suggestions on how to install compression connectors on flooded
RG6 quad shield coax with PE jacket? I'm using Belden Snap-N-Seal RG6QS
compression connectors but they're nearly impossible to slip on far enough.
I've tried removing the outer braid and foil and still no luck. Maybe I
should be using different connectors? The coax I'm using for the beverage is
Commscope F6SSEF / 4561804.
Thanks,
Tony/K1AMF
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|