I forgot to include the part number of the red sleeve connectors - SNS1P6U
73 NA4M
On Nov 17, 2014, at 3:06 PM, Phil Duff <na4m@suddenlink.net> wrote:
> There are different SNS F connectors. The SNS connectors will have different
> sleeve colors depending on application.
>
> http://www.tnb.com/pubint/docs/snapnseal.pdf
>
> I use the red sleeve connectors on flooded double shielded Commscope RG6.
> Using the recommended stripping and compression tool and fold the braid back
> and it goes on easily and fits fine.
>
> 73 Phil NA4M
>
>
>
> On 11/17/2014 14:44, Tony K1AMF wrote:
>> Anyone have any suggestions on how to install compression connectors on
>> flooded RG6 quad shield coax with PE jacket? I'm using Belden Snap-N-Seal
>> RG6QS compression connectors but they're nearly impossible to slip on far
>> enough. I've tried removing the outer braid and foil and still no luck.
>> Maybe I should be using different connectors? The coax I'm using for the
>> beverage is Commscope F6SSEF / 4561804.
>
> --
> Phil Duff
> Georgetown, TX
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
-. .- ….- --
Phil Duff na4m[at]suddenlink.net
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|