Mike,
The closest element (Hi-Z element #2) of my Hi-Z 4sq is 70 ft from my 1/4 wave
160m hat loaded vertical & it has worked fine for 3 years. I am feeding the
feedpoint at 134 ft up the antenna.
Bill N3RR
On Nov 15, 2015 12:33 PM, Mike Greenway <K4PI@BELLSOUTH.NET> wrote:
>
> I have used the HI Z rx system and also the DXE ones. HI Z said in the past
> no need for a sequencer to get power off the amps if the xmit ant was close
> to the rx system antennas. Close I would say 60 foot. DXE has always
> suggested using a sequencer to get power off the amps during xmit. I am
> going to be forced to move a DXE system within 65 ft or so of my 160 vertical
> and wonder if anyone has had any experience of using the DXE without a
> sequencer close to their xmit antenna. Just hate to install one more thing I
> could get around but will if absolutely necessary. I know moving it closer
> is not an ideal situation but you do what you have to. Any input? 73 Mike
> K4PI
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|