Just had Norm's Rotor Service rebuild a T2X...nice job...very fast, 3
days! For both rotor and control box, labor was 50 bucks plus parts.
Mine cost @ 150 bucks which included a new lower casting, a brake delay,
a bunch of parts, stainless connector board (which I prefer) and all new
stainless bolts. Most likely comparable to hygain prices but only at
Norms can you get the stainless board and brake delay.
73,
Bob, K3GT
WIN95 USER wrote:
>
> I have a Ham IV that has been up for a long time and the indication
> function does not work from about 20 degrees to about 180 degrees.
> Where is the best place to have it either repaired or rebuilt. I am not
> familiar with Norm's Rotor service in Maryland, but I think I remember
> some one on the net saying the factory would rebuild them for a
> resonable fee. Anyone had any experience with either one of these
> sources or someone else for that matter.
> Thanks and 73s
> Bob Harris
> WA8TUO
m
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|