>I have an Orion 2800 mounted 8 feet down in the Rohn 25G tower at the
junction
>of two sections. The standard AS25G rotor plate works very well there.
As far
>as the section joint not being big enough to accomodate the OR2800, I'm
>confused. I have been able to insert the rotor through the "Z" braces and
>lowered down to the mounting plate. No braces were removed or modified. I
also
>have a 2nd AS25G mounted about two and a half feet above the OR2800 drive
plate
>that holds a thrust bearing. This allows me to remove the OR2800 for service
>and have a lower support for the mast. This was NOT an easy fit!
I guess my question should have been....How is everyone mounting their
rotors on these stacked HF beam setups. I can't possible see anyone putting
up two HF beams on a mast and placing the rotor 12" below the thrust bearing.
KK5LC
Shane Dugas
Prairieville, LA
Shane@eatel.net
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|