Has anyone ever had an experienced a defective tower section. I
purchased a BAS25G top section about a month ago and I finally got around to
messing with it yesterday when I realized that it was really out of square.
It's definately a defect from the factory. I tried it on 4 different
sections of tower and I get the same results. I put a square on the legs
and they are definatly not square with the top plate. It doesn't have any
cross bracing so I can understand where it may be a difficult piece to
build very accuratly. This is a first for me as well as everyone else I've
talked to. Every problem I've ever seen with legs not lining up was due to
a bent leg or crossbracing and I can't ever recall seeing a bad tower
section due to manufacturing errors.
Now all I've got to do is get it replaced.
KK5LC
Shane Dugas
Prairieville, LA
Shane@eatel.net
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|