Hi Barrie,
I sell Rohn TB3 thrust bearings that are heavy duty but require 4 holes for
mounting. You can see a diagram of the hole pattern at the following address:
http://www.reprise.com/antronics/thrust_bearing.asp
I have these in stock for $78.60 plus shipping.
Stan
w7ni@easystreet.com
Barrie Smith wrote:
> Hello:
>
> My previous question regarding a thrust bearing for a Telex Hy-Gain HG70-HD
> did not yield much response.
>
> Perhaps a better question would be: Where can I get a very heavy-duty
> thrust bearing that will accept a 2" mast, and can be bolted to the flat
> steel plate at the top of the tower.
>
> Drilling, welding, machining or adapting is no problem. I just need the
> bearing and bearing holder.
>
> The reason I need "very heavy duty" is because I'll have a 26' X 27'
> H-frame, four relatively large 6M beams, and an elevation rotor on the mast
> above the tower.
>
> Thank you,
>
> Barrie, W7ALW, Missoula, Montana
>
> List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
> Trylon Titan towers, coax, hardline and more. Also check out our self
> supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
>
> -----
> FAQ on WWW: http://www.contesting.com/FAQ/towertalk
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|