I crossed this bridge before and the easy, but expensive, way out is to
use the Wireman's (or equivalent) #304 where 2-#14, 6-#18 are
recommended for runs up to 325 feet. However, others suggested using
Romex #14 for the motor terminals (1 and 2 on the T2X) and an
inexpensive 6 -#18 conductor cable for the other terminals. The latter
is certainly the inexpensive way out.
73, Joe
Allen R. Brier wrote:
> What is the minimum rotor control cable size for a 250 ft run to a
> Tailtwister?
>
>
>
> Allen Ross Brier, N5XZ SET
>
> BriTech Systems Incorporated
>
> NICET Fire Alarm Level IV
>
> NICET Sp. Hazards / Sprinkler Systems Level I
>
> 1515 Windloch Lane
>
> Richmond, Texas 77469-2553
>
> (281) 342-1590
>
> (281) 342-0940 (FAX)
>
> (713) 705-4801 (Cell)
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|