Towertalk
[Top] [All Lists]

Re: [TowerTalk] Shipping Companies

To: Jon Pearl - W4ABC <jonpearl@tampabay.rr.com>
Subject: Re: [TowerTalk] Shipping Companies
From: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
Date: Fri, 03 Dec 2010 09:54:24 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>

On 12/2/2010 11:43 PM, Jon Pearl - W4ABC wrote:
> Hi Roger.
>
> I've managed to move a couple of large crank-up towers by following 
> the Egyptians example.  I've used large diameter PVC pipe in 3' or 4' 
> lengths as rollers to simply roll the tower around the property.  When 
> one of the pieces of pipe pops out from behind the tower it is picked 
> up and thrown down in front of the tower in the path of travel.  You 
> can easily slide the tower laterally on the slippery PVC by butting 
> pipe pieces end to end to make turns as you go.
>
> You'll shove the biggest tower pieces around your property with little 
> effort and no ruts.
I'm looking for the photos of when we moved a crated airplane from the 
garage to the new shop.  We used the big round wood fence posts. They're 
just not as straight or smooth as the PVC <:-))  However to get a 3000# 
tower across the yard would take more than either of those.  It would 
take a pair of rubber tired dollies and that would be at least 14" 
tires. There is basically no way to get from the driveway to the back of 
the shop except along the North side of the shop and that would take 
some large tires to spread the load enough to keep from sinking in. That 
means the work would almost have to be done after the ground freezes 
deep enough to support the load. The past few years would  have been 
just barely sufficient.

73

Roger (K8RI)
>
> Tower: --------
> Roller: |
>
> ---|---------|----------|----------|---->
>
>
> You get the idea!
>
>
> 73,
>
>
> Jon Pearl - W4ABC
> http://w4abc.com
>
>
>> Here?
>> I can rig something for unloading, (I have a lot of steel, a couple of
>> 4000# engine hoists, and two 4 ton cable hoists) but getting something
>> heavy across the yard and around behind the shop is a real challenge.
>> It'd take one of those fork lifts with the large pneumatic tires. I'd
>> have to do it in the winter when the ground is frozen and wait till
>> spring to install.
>> One of the old farm wagon frames would be ideal for that and might even
>> work in the summer, but certainly not in the spring.
>>
>> It took two years to get rid of all the ruts the last time I had a truck
>> (Hy-Ranger) out there, but I'd sure like to replace that 25G with a good
>> crank up without spending a fortune.
>>
>>
>> 73
>>
>> Roger (K8RI)
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>