Towertalk
[Top] [All Lists]

Re: [TowerTalk] Crank up tower bracing rubbing against cable

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Crank up tower bracing rubbing against cable
From: Justin Whitstine <powdermnky007@hotmail.com>
Date: Thu, 18 Oct 2012 14:16:16 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I have no experience at all.  But, I would think securing a piece of teflon or 
delrin to the tower would be a better way of accomplishing your goals.  Bending 
the tower supports doesn't seem like the safest idea.




> Date: Thu, 18 Oct 2012 11:31:57 -0700
> From: jj_2_woo@yahoo.com
> To: towertalk@contesting.com
> CC: richard@karlquist.com
> Subject: Re: [TowerTalk] Crank up tower bracing rubbing against cable
> 
> Hi All,
> 
> Thank you for the replies.  Some of you replied to me in private.  Unless I'm 
> told otherwise I plan to bend the Z bracing a bit to eliminate the 
> interference.  I'm not sure yet on how to do that.  I do have a sledgehammer. 
>  Maybe I can take a rebar and hammer the rebar against the center of the Z 
> brace.  The steel used in my tower is very soft and it bends easily.  I will 
> give it a try and let you know how it turned out.
> 
>  
> Best Regards,
> Jonathan Woo, W6GX
> (970) 646-1711
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
                                          
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>