Date: Thu, 18 Oct 2012 09:49:32 -0700 (PDT)
From: SPWoo <jj_2_woo@yahoo.com>
To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Crank up tower bracing rubbing against cable
Hi All,
I've discovered that my less than a year old TX-472 tower has three places
where the steel cable is rubbing against the tower.? Attached below is a link
to some photos of the problem.? In one spot the interference has worn away a
lot of metal and it caused some cable wear.? I was wondering if anyone has
experienced this and what I could do to remedy it.? I've sent the photos to US
Tower and I'm still waiting for their response.? I crank my tower down every
day and sometimes under light wind condition.? I don't know if wind has
anything to do with it.? Thank you and very 73.
http://www.flickr.com/photos/26071865@N02/
?
Best Regards,
Jonathan Woo, W6GX
(970) 646-1711
## The big question is....... how did any of this get past their.......”
quality control” ?? The braces could EASILY have been checked, on a
section by section basis,
well before they assembled the sections inside of each other ! And after
the sections had been assembled, and cables strung, it should have been
re-checked again, before
shipping. Don’t they extend it to full height and back down at least 1-3
times before deeming it fit to sell ? I’d be just pissed.
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|