Towertalk
[Top] [All Lists]

Re: [TowerTalk] Crank up tower bracing rubbing against cable

To: "'Jim Thomson'" <jim.thom@telus.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Crank up tower bracing rubbing against cable
From: "Doug Turnbull" <turnbull@net1.ie>
Date: Fri, 19 Oct 2012 12:07:56 +0100
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
OMs and Yls,
    Sometimes in shipping or handling by the installers cross bracing may be
distorted.   It should be reasonably easy to sort with some reasonable
hammer work - lump hammers are not needed.

                    73 Doug EI2CN    

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Jim
Thomson
Sent: 19 October 2012 11:35
To: towertalk@contesting.com
Subject: [TowerTalk] Crank up tower bracing rubbing against cable

Date: Thu, 18 Oct 2012 09:49:32 -0700 (PDT)
From: SPWoo <jj_2_woo@yahoo.com>
To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Crank up tower bracing rubbing against cable

Hi All,

I've discovered that my less than a year old TX-472 tower has three places
where the steel cable is rubbing against the tower.? Attached below is a
link to some photos of the problem.? In one spot the interference has worn
away a lot of metal and it caused some cable wear.? I was wondering if
anyone has experienced this and what I could do to remedy it.? I've sent the
photos to US Tower and I'm still waiting for their response.? I crank my
tower down every day and sometimes under light wind condition.? I don't know
if wind has anything to do with it.? Thank you and very 73.

http://www.flickr.com/photos/26071865@N02/
?

Best Regards,
Jonathan Woo, W6GX
(970) 646-1711

##  The big question is....... how did any of this get past their......."
quality control" ??      The braces could EASILY have been checked,  on a
section by section basis,
well before they assembled the sections inside of each other !     And after
the sections had been assembled, and cables strung, it should have been
re-checked again, before
shipping.     Don't they extend it to full height and back down at least 1-3
times  before deeming it fit to sell ?    I'd be just pissed.

Jim  VE7RF
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>