Last week I had the same issue with a piece of new Rohn 55. I did not
pre-fit them, but did noticed the problem visually and used a floor jack to
straighten it out. You can easily check all of the leg spacing with a tape
measure before installing. There is nothing precise about tower sections or
hardware.
John KK9A
To:towertalk@contesting.com
Subject:[TowerTalk] Rohn 45
From:les <lkemble@charter.net>
Date:Wed, 24 Jul 2013 15:48:04 -0400
List-post:<towertalk@contesting.com">mailto:towertalk@contesting.com>
I am pre assembling a rohn45 tower but one section will not line up, it
appears to be about 1/8 of an inch out on one leg. What is the best way to
align the tower section?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|