Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn 45

To: towertalk@contesting.com, n4gnr@windstream.net
Subject: Re: [TowerTalk] Rohn 45
From: K7LXC@aol.com
Date: Thu, 25 Jul 2013 05:46:32 -0400 (EDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
>  Two things you can do...look down all three legs of the 2  sections you 
are 
trying to mate up..
there may be one leg bent slightly  from a drop..This is a common 
problem...you can bend it back  carefully
with a short scissor jack....
 
    Hmm? Where is the opposition for the jack to  push against? Another 
leg? Won't that bend the other leg too?
 
>  Or you may be able to "adjust" the legs by bending the  cross bars,,with 
a 5 lb hammer,,be careful,,
 
    I would think that this would have a tendency to  dent the leg - not a 
good thing. 
 
    Using another section as a lever has been  mentioned. You can also use 
a piece of piece. All it has to do is slip over the  leg and pry it as 
needed. 
 
Cheers,
Steve        K7LXC
TOWER TECH 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>