Good idea.
I've also used a couple of pieces of 3/8" to 1/2" threaded rod with a female
threaded coupler. You can use this to spread tower legs or bring them
closer with the something to grab the tower legs on the end of the threaded
rod. Simple and amazingly effective. I hope my brief description paints a
clear picture.
73, Bob - W3YY
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
Cqtestk4xs@aol.com
Sent: Thursday, July 25, 2013 1:18 AM
To: TOWERTALK@contesting.com
Subject: Re: [TowerTalk] Rohn 45
You can bang on the various cross bars with a mallet on the two towers
where they meet up. Pound up to bring the legs closer, pound down to
spread them.
Bill K4XS/KH7XS
In a message dated 7/25/2013 12:58:40 A.M. Coordinated Universal Tim,
lkemble@charter.net writes:
I am pre assembling a rohn45 tower but one section will not line up, it
appears to be about 1/8 of an inch out on one leg. What is the best way to
align the tower section?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|