Towertalk
[Top] [All Lists]

Re: [TowerTalk] Connecting Flat Copper to 5/8" Ground Rod

To: "Ray Benny" <rayn6vr@cableone.net>, "TowerTalk" <TowerTalk@contesting.com>
Subject: Re: [TowerTalk] Connecting Flat Copper to 5/8" Ground Rod
From: "Mark Robinson" <markrob@mindspring.com>
Date: Sun, 13 Oct 2013 21:41:22 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I preformed the copper strap around half of the copper clad ground rod and silver soldered the strap to the rod.


Mark N1UK



----- Original Message ----- From: "Ray Benny" <rayn6vr@cableone.net>
To: "TowerTalk" <TowerTalk@contesting.com>
Sent: Sunday, 13 October, 2013 5:47 PM
Subject: [TowerTalk] Connecting Flat Copper to 5/8" Ground Rod


Has anyone come up with a way to connect flat copper straps to ground rods? DXXE sells copper clamps w/ hardware, but at $35 a pop, I hoping that there
is a more reasonable way to get the job done.

My copper strap is 2" wide, by 6ft, and about 18 ga, but not sure.

Tnx,

Ray,
N6VR
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>