Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rust & paint

To: towertalk reflector <towertalk@contesting.com>
Subject: Re: [TowerTalk] Rust & paint
From: Mike Reublin NF4L <nf4l@comcast.net>
Date: Mon, 2 Dec 2013 11:42:01 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks Patrick. I've had good results with Rustoleum paints also. This is 
apparently a new product.

Mike NF4L

On Dec 2, 2013, at 9:11 AM, Patrick Greenlee <patrick_g@windstream.net> wrote:

> My back porch is held up by 4x4 square steel tubing columns from the patio 
> below and 3x8 steel tubing lattice under the porch slab.  All this steel was 
> some rusty when installed.  I painted it all (with no primer) using Rustoleum 
> brand "Hammertone" paint which is designed to go on over light rust without 
> primer.  It was available in two colors, silver and black and I chose black. 
> Now over 8 years later the paint looks nearly new.  No rust, just nice black 
> paint.  I have used this paint on several projects since with great success. 
> I have used it in both quarts and aerosol spray cans. The spray cans are 
> offered at Lowe's in some other colors but the quarts are only stocked in 
> silver and black.  Special order for gallons or for other colors in cans.
> 
> I put up a parking lot barrier of pipe in the ground vertically and 
> horizontal pipe connecting the verticals.  Painted the pipe with the green 
> tinted paint and years later it is good as new.
> 
> I have several quart cans of silver tinted as dark green as there was room 
> for pigment in the new full cans. It is a light metallic green, a little aqua 
> influence...  It works fine too.  I painted the custom base I welded up for 
> my Hy-Gain Hy-Tower vertical antenna on the roof of my all metal barn. It was 
> pretty rusty but not flakey. Going on two years and it looks fine.
> 
> I spray welded repairs to tractor implements with this paint and it works 
> well.
> 
> I also have experience with cold galvanize but for rusty steel I choose the 
> Rustoleum and don't have to clean off the light non-flakey rust first.  Of 
> course YMMV.
> 
> I used an earlier product by Rustoleum, a primer to go on over rust with 
> similar chemistry to the above described paint. I used it on keel bolts of a 
> 32 ft sailboat. These were often immersed in salt water. Years later a marine 
> surveyor commented on how well preserved they were.
> 
> 73,
> 
> Patrick AF5CK
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>