Having been reading about soldering irons I have a question. Just
recently had to do some soldering about 25 feet up my tower, I had to
run 150 feet of #12 extension cord out and part way up the tower. I was
using a 25 watt iron that gets a tip temp of 750 degrees F. An
occasional breeze would hinder the solder from melting using a conical
tip. I did manage to get the job done but was wondering if the
screwdriver tip and a 1000 degree F tip would have made the job any
easier, retaining more heat when the breeze blew. Any thoughts on this
would be helpful for the next time.
Thanks
Bill, AI3Q
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|