The Ham M and Ham 1 - 4 series rotators use (4) 1/4 " bolts.
The T2X uses (6) 1/4" bolts. The two additional bolts are in the same
radius as the 4 other bolts, but just centered between two of bolts on
opposite sides.
Ray,
N6VR
On Dec 1, 2018 5:23 PM, <john@kk9a.com> wrote:
I would not let bolt pattern limit your rotator choices. I have not owned a
Hy-Gain rotator in decades. Drilling holes or elongating the existing ones
is very easy. Your rotator shelf may already have elongated holes, I do not
recall doing anything to install a Yaesu G-2800 in my P40A Rohn 55G tower.
John KK9A
Kim Elmore N5OP Wrote:
I'm investigating rotor that will fit the same bolt pattern as a T2X but
that are a bit beefier. Mine works well, but in windy conditions, I
can't turn may antennas due to wind imbalance. What beefire rotators
will accommodate the same bolt pattern?
Kim N5OP
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|