I tried all over the internet to find those screws. I did get some from
Hygain/MFJ. I had a brand new Ham IV on an MA-40 mounted on top and the screws
holding the top and bottom pieces together came loose and the antenna fell off.
Screws were not put on with Locktite. Sent back to Hygain for replacement.
They replaced the top half and installed new screws. Again no Locktite. I
removed and reinstalled the screws with Locktite. Hopefully this will keep it
from happening again. All the rotors I refurbish I use Locktite on the screws.
Skip Bolnick, KJ6YCommunications Service Cowww.kj6y.com818-522-5421 In a
message dated 2/9/2021 8:19:30 AM Pacific Standard Time, marvs@att.net writes:
Does anyone know what size bolt is used to hold the upper bell housing to the
lower housing in a Ham IV? Marv
K7IU_______________________________________________
_______________________________________________TowerTalk mailing
listTowerTalk@contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|