Towertalk
[Top] [All Lists]

Re: [TowerTalk] Ham IV part identificaiton

To: kj6y@aol.com, marvs@att.net, towertalk@contesting.com
Subject: Re: [TowerTalk] Ham IV part identificaiton
From: Alan Swinger <awswinger@earthlink.net>
Reply-to: Alan Swinger <awswinger@earthlink.net>
Date: Tue, 9 Feb 2021 17:38:41 -0500 (GMT-05:00)
List-post: <mailto:towertalk@contesting.com>
Marv - Had a similar problem ~3 yrs ago w/ a NEW Ham IV bought from HY Gain. It 
was mounted internally in my TX-472 and turning a 4 El SteppIR. A few mos after 
install, I went up the tower to see why my in shack indicator was showing the 
antenna/rotor to be free-wheeling. Thought maybe the mast clamp had come loose, 
but when I found a bolt sitting on the rotator motor shelf I looked further and 
found that the bolts between top and bottom of the rotor had backed out! As 
such the only thing keeping the two halves together was the weight of the beam. 
So, since tilting the tower over would result in rotor separation, hired a 
crane to lift off the beam and mast first . . . and when tower tilted the rotor 
bled ball bearings. Hy Gain made good and sent a new rotator (Tech comment was 
- you, too . . there were others so HY-Gain knew several yrs ago), but the 
crane and all the sweat equity to reinstall the new rotator (ultimately a Yaesu 
2800) were my costs. Sold the several Ham IVs I had.
Good luck
Alan K9MBQ


-----Original Message-----
>From: kj6y--- via TowerTalk <towertalk@contesting.com>
>Sent: Feb 9, 2021 12:37 PM
>To: marvs@att.net, towertalk@contesting.com
>Subject: Re: [TowerTalk] Ham IV part identificaiton
>
>I tried all over the internet to find those screws. I did get some from 
>Hygain/MFJ.  I had a brand new Ham IV on an MA-40 mounted on top and the 
>screws holding the top and bottom pieces together came loose and the antenna 
>fell off.  Screws were not put on with Locktite.  Sent back to Hygain for 
>replacement.  They replaced the top half and installed new screws.  Again no 
>Locktite. I removed and reinstalled the screws with Locktite.  Hopefully this 
>will keep it from happening again.  All the rotors I refurbish I use Locktite 
>on the screws.   Skip Bolnick, KJ6YCommunications Service 
>Cowww.kj6y.com818-522-5421  In a message dated 2/9/2021 8:19:30 AM Pacific 
>Standard Time, marvs@att.net writes: 
>Does anyone know what size bolt is used to hold the upper bell housing to the 
>lower housing in a Ham IV?  Marv 
>K7IU_______________________________________________   
>_______________________________________________TowerTalk mailing 
>listTowerTalk@contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>