Got the call from Tim at Rohn
ID is 2.06 inches
Thanks again for the help! Great group here!
Regards,
Mark, K1RX
> On May 26, 2021, at 10:55 AM, Stan Stockton <wa5rtg@gmail.com> wrote:
>
>
> Said to accept maximum of 2 inch OD so has to be a few thousandths over that.
> You couldn't even fit a 1.5 inch schedule 40 pipe through it if 1-7/8.
>
> Stan, K5GO
>
>> On Wed, May 26, 2021, 9:03 AM CEPitts <cpitts@ec.rr.com> wrote:
>> Hi Mark my small metal caliper measures at 1 and 7/8" or 27mm....if it is
>> off it only by 1mm according to my handy little caliper. If others respond
>> hopefully they confirm what I have provided. Charle4s "Ed" K5OF in NC
>>
>> Hello group!
>>
>> Could someone here give me the precise inside diameter of this bearing? Quick
>> checks in the Rohn catalog (over 230 pages) I was unable to find it.
>>
>> Thanks!
>>
>> Regards,
>>
>> Mark, K1RX
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|