That makes sense: a 2" mast just barely fits. If the mast clamp deforms it even
slightly, it won't fit.
73,
Scott K9MA
----------
Scott Ellington
--- via iPad
> On May 26, 2021, at 10:53 AM, Mpridesti via TowerTalk
> <towertalk@contesting.com> wrote:
>
> Got the call from Tim at Rohn
>
> ID is 2.06 inches
>
> Thanks again for the help! Great group here!
>
> Regards,
>
> Mark, K1RX
>
>
>> On May 26, 2021, at 10:55 AM, Stan Stockton <wa5rtg@gmail.com> wrote:
>>
>>
>> Said to accept maximum of 2 inch OD so has to be a few thousandths over
>> that. You couldn't even fit a 1.5 inch schedule 40 pipe through it if 1-7/8.
>>
>> Stan, K5GO
>>
>>>> On Wed, May 26, 2021, 9:03 AM CEPitts <cpitts@ec.rr.com> wrote:
>>> Hi Mark my small metal caliper measures at 1 and 7/8" or 27mm....if it is
>>> off it only by 1mm according to my handy little caliper. If others respond
>>> hopefully they confirm what I have provided. Charle4s "Ed" K5OF in NC
>>>
>>> Hello group!
>>>
>>> Could someone here give me the precise inside diameter of this bearing?
>>> Quick
>>> checks in the Rohn catalog (over 230 pages) I was unable to find it.
>>>
>>> Thanks!
>>>
>>> Regards,
>>>
>>> Mark, K1RX
>>>
>>> _______________________________________________
>>>
>>>
>>>
>>> _______________________________________________
>>> TowerTalk mailing list
>>> TowerTalk@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|