On 10/23/2021 4:48 AM, Mark - N5OT wrote:
Hey youall,
I want to model Rohn 25G as a transmitting antenna. Has anyone learned
how to do that fairly accurately in K6STI's AO program? In addition to
some length of regular straight sections, my tower has a factory 8'
tapered top section which I would extend with a 2" stinger and a
single-point pier base that is basically a 10 foot section with 3 feet
of taper to a flange added. It appears to be "factory" although I have
never seen one in person and it could be a one-off.
1. How do I model these tapers?
I've never seen AO, but in EZNEC it's pretty easy.
2. How do I model the tower itself? Do I call it "10-inch diameter
steel?" Larger? Smaller?
I've seen a simple equation for modeling a straight triangular tower in
NEC. As I recall, the diameter worked out to be around 0.65 the width of
a side. This would account for modeling it as a radiator.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|