REN:
At 10:03 11/16/2002 -0500, REN wrote:
>Looking for input (no pun) on best way to interface TX audio from
>computer sound card with TS950-S - I have the radio shack xfomer 1K:8
>ohm - I also want to use my Heil Pro head Set and or the Heil Classic -
>Tried to couple via the mic connector with both in parallel but loaded
>down the Heil. Also tried the Patch input but audio level too low. Any
>other tried and proven methods with this setup.
I think your 1K:8 ohm xformer is the problem.
I use the Radio Shack 270-054 Ground Loop Isolator xformers between
my sound card line output and my TS-950-SDX
phone patch input and I have plenty of audio level. I also use leave a
Heil Pro head set on the front MIC connector without any problems.
With the 950, double pressing the LSB or USB mode buttons
cuts out the mic input so ambient room noise doesn't get
accidentally xmitted with your digital signals on the rear connections
Similarly, I have the 950 phone patch output connected to the
sound card line input through another RS 270-054 for sound
card digital modes receive.
-Joe, NA9A
|