Actually, this is a re-installation of WL so the writelog.ini file is
bare-bones. No other LPT config statements exist in the config.
Also, Device Manager shows LPT1 as 0x0378-0x037F and 0x0778-0x077B.
0x0378-0x037F is what is configured in UserPort. I also tried 0x0778-0x077B
but that could not be accepted.
LPT2 still shows as the active LPT port in WL.
Do people have this kind of difficulty with Direct-IO ?
Bob
-----Original Message-----
From: VA3MW [mailto:va3mw@rogers.com]
Sent: Friday, May 02, 2003 5:07 PM
To: Bob Lafont; Writelog
Subject: Re: [WriteLog] UserPort
Try deleting all the LPT entries in writelog.ini.
That was the only way I got it to work.
Mike
----- Original Message -----
From: "Bob Lafont" <bob@wa2mno.ampr.org>
To: "Writelog" <writelog@contesting.com>
Sent: Friday, May 02, 2003 1:01 AM
Subject: [WriteLog] UserPort
> I am running XP and cannot get UserPort to work properly. Following the
> instructions provided by UserPort I added LPT1 with 0x378-0x37B. After
> selecting Update, Start and Exit and starting WriteLog I find that LPT2 is
> selectable in the setup screen, not LPT1. When I select both CW and DVK
> using LPT2 the sound card generates audio just fine but when switching to
CW
> I cannot get it to generate at CW at all.
>
> Any ideas on what my problme might be?
>
> Bob /wa2mno
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
|