Hello
After doing a system restore, I unziped the contents of the
wl1058eupg.zip to another folder "as I always do" and then ran setup.
Program appeared to upgrade OK and the WL splash screen said 10.58E when
starting. However, when I click on a recently used log I get an error
"Can't open DXCC data base file DXCCWAE.DAT" then log opens. If I enter
a call I get no country information.
Running XP SP2 all updates.
--
73
Steve AI9T
http://www.ai9t.com
QSL via LOTW and EQsL
Steve AI9T wrote:
>Hello
>
>*I'm currently running 10.57H* which one of these updates should I
>download and install. One didn't work (
>
>wl1058emsiupg.zip) After this failed I tried the 2nd (wl1058eupg.zip)It said I
>needed ver 10. After that Writelog was gone.
>
>
>Thank goodness for system restore. That's what I had to do to get back
>to where I was. What did I do wrong?
>
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|