Gordon,
Have you gone to Setup/Ports yet and defined which port you intend to use
for CW? Notice there are three columns for indicating the Com ports to use
for CW, DVK and Antenna relay. Assuming your CW interface is between Com1
thru Com4, click the radio button for that port. If your com port is higher
than Com4 then you will need to go into the writelog.ini file and reassign
the higher numbered port to one between 1 - 4 as that is all WL will work
with. While you are there make sure the Rig Type for your CW port is
defined and set the Baud Rate, Poll and Comm PTT settings. Also on that
window check the button at the bottom right hand side called CW PTT...
Click that and select the radio button for On LPT pin 16/COMM RTS. That
puts the signal on the RTS line of your Com port.
73,
Gary AL9A
----- Original Message -----
From: "N6WK" <n6wk@n6wk.com>
To: <writelog@contesting.com>
Sent: May 26, 2008 2:19 PM
Subject: [WriteLog] Setting up WL with FT-2000
> Hi All, I just purchased WriteLog.
> I am trying to set it up with my FT-2000.
> I have my serial cable connected and I can poll the rig. No problem
> there. When I try to use any of the "F" keys, the PTT activates, but NO
> CW is being sent.
> Can someone please advise what I am doing wrong?
> My Yaesu software operates the rig just fine and my MMTTY software works
> great with it as well as Digipan and another logging program I own, but
> I can't get WL to send any CW. I am sure it is something I am
> overlooking, yet I can not seem to figure out what it is.
> thanks,
> Gordon
> N6WK
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|