I made sure the settings were correct in the entry window.
A few other things I’ve tried:
Changing the data rates – no joy.
Changing the line in the setup window – no joy.
Swapping the location with the working IC-7200 – no joy.
I’ve done several full reloads of writelog – no joy.
Getting frustrated . . .
Tom, AB3IC
From: Jim Rhodes
Sent: Thursday, November 17, 2011 1:41 AM
To: Tom Shelton
Cc: writelog@contesting.com
Subject: Re: [WriteLog] No Rig! problem
You did set the frequency in that entry window to "rig on com 4" didn't you?
Jim K0XU Sent from my Xoom tablet
On Nov 16, 2011 6:52 PM, "Tom Shelton" <gl1800winger@verizon.net> wrote:
I last wrote to you about a few problems I was having. A couple of them I
figured out, but one is still a mystery to me.
I have a Kenwood TS-2000 using port 4 (9600, N, 8, 1). I’m using a USB/Serial
adapter here. In the entry window, the rig is showing as No Rig! instead of the
frequency and mode. I also have an IC-7200 using port 5 (same as above). This
rig shows up properly in the in the entry window.
I’ve verified both configs in the writelog.ini file.
Both radios work well with Ham Radio Deluxe.
I’d like to use the TS-2000 for the Sweepstakes this weekend, so having the
frequency is necessary for the log. Please help soon...
Tom Shelton, AB3IC
No electrons were harmed in the sending of this message, although several
were terribly inconvenienced.
Draco Dormiens Nunquam Titillandus
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|