I don't have this under Win7 however under WINXP I did find that even
thought the LPT port looked like an normal LPT port to the OS, the real
hardware address of the port was not at your normal address's 0x378/0x278
etc. Instead I found my hardware at a much different address (look in
device manager)
Once I put the real hardware address into writelog.ini (LPT1=0xDCD8 in my
case) , and setup a proper port pass thru driver (I use AllowIO) it worked
like a champ.
This had me stumbling for quite a while and I had tried a number of
supposed 'real' LPT ports before figuring this out.
Again this is under WinXP, not tried under Win7 but might be the same.
Dan K0TI
On Fri, May 3, 2013 at 5:48 PM, Mark Klocksin <mpklocksin@ameritech.net>wrote:
> I think Steve has the right idea. Parallel ports haven't been seen on new
> computers in…what…10 years? It seems time to let the technology go. (That
> said, I will try to hang on to serial ports as long as possible because so
> much of our ham gear needs serial ports.)
>
> Back to your issue, I was surprised to see Steve's tale of woe. My
> limited experience would tell me an internal card would be recognized by
> the OS as a legitimate LPT port. And if that is the case, then Writelog
> should just issue requests to the OS, which would instruct the card to
> behave as we want it to. So I think it should work.
> And this link says Windows 7 does support LPT ports:
>
> http://answers.microsoft.com/en-us/windows/forum/windows_7-hardware/parallel-ports-and-windows-7/6b24de6f-6896-439a-8223-e59985907f68
>
> I said "limited experience" earlier because I have not used an internal
> LPT port in a Windows 7 computer. However, I DO have a PCMCIA dual-port
> serial card adapter I use in my Windows 7 laptop. That card works fine--in
> Windows 7 and also in Windows 8 for that matter. The OS does indeed see
> that as two "real" COM ports.
>
> Best of luck,
>
> 73, Mark WA9IVH
>
>
> On May 3, 2013, at 4:14 PM, VK3TDX@aol.com wrote:
>
> > Dave - I spent DAYS trying to get my Win 7 64 bit system to interface
> with
> > a special LPT port card I purchased for my computer for specifically CW
> > operation. Never could get it working even with the tech supports guys
> at
> > the computer shop. I even have the XP alternate operating system
> installed
> > through Win 7 and still never could do it.
> >
> > Since I have 2 serial ports available I just gave up on LPT and just
> wired
> > up serial for RTTY and CW interface. Please post your solution if you
> find
> > one.
> > Thanks and good luck
> > Steve VK3TDX
> >
> >
> > In a message dated 4/05/2013 3:32:15 A.M. AUS Eastern Standard Time,
> > k6ll@arrl.net writes:
> >
> > Does Writelog support LPT port functions (specifically A/B focus
> > and CW keying) on Windows 7 x 64 Bit?
> >
> > I have a desktop computer running Windows 7 x 64 that I want to
> > start using as my contest computer. I have one of these LPT
> > thingies on order:
> > http://www.newegg.com/Product/Product.aspx?Item=N82E16815201049
> >
> > Thanks.
> >
> > Dave Hachadorian, K6LL
> > Yuma, Arizona
> >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> > WriteLog on the web: http://www.writelog.com/
> >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> > WriteLog on the web: http://www.writelog.com/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
--
Dan K0TI
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|