Hi,
I'm setup for the NEQP, SSB works fine. when I switch to CW the
radio keys and stays keyed, can not find what I have setup wrong.
Radio - Kenwood TS590sg Ports set to COM18 115200 - works fine,
tracks radio frequency/mode
CW - COM 7 DTR= CW RTS= PTT
CW Options:
PTT Control (CW Mode ONLY) None (QSK) selected (tried "as specified
in Ports", no difference)
PTT to CW delay 0
PC generates sends CW space on startup - Checked (also tried unchecked
- no difference.
What else should I check?
This used to work, so don't know what changed except upgraded to 12.59F
, so downgraded to 12.56c, no change.
The same hardware setup works with N1MM and DX Labs, so I know the
hardware is good!!!!
Thanks,
Gordon - N1MGO
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|