Joe,
Thanks, Are you talking about on the radio control port (COM18 in
my case, the USB port) or the COM port used for PC generated CW/PTT/FSK,
(Com7 in my case)? I'm not using the same port to control the radio and
send cw/ptt.
Thanks,
Gordon
On 5/2/2021 10:57 AM, Joe Subich, W4TV wrote:
The standard Kenwood definition asserts RTS unless you are using it
for CW. Look at the help file for information on preventing the
rig driver from asserting RTS (and DTR) - note it involves editing
Writelog.ini.
73,
... Joe, W4TV
On 2021-05-02 9:47 AM, Gordon LaPoint wrote:
Hi,
I'm setup for the NEQP, SSB works fine. when I switch to CW the
radio keys and stays keyed, can not find what I have setup wrong.
Radio - Kenwood TS590sg Ports set to COM18 115200 - works fine,
tracks radio frequency/mode
CW - COM 7 DTR= CW RTS= PTT
CW Options:
PTT Control (CW Mode ONLY) None (QSK) selected (tried "as
specified in Ports", no difference)
PTT to CW delay 0
PC generates sends CW space on startup - Checked (also tried
unchecked - no difference.
What else should I check?
This used to work, so don't know what changed except upgraded to
12.59F , so downgraded to 12.56c, no change.
The same hardware setup works with N1MM and DX Labs, so I know the
hardware is good!!!!
Thanks,
Gordon - N1MGO
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|