I modified my sub receiver slightly:
I removed the chassis wire from pin 1 of J6007, installed a 'Y' pin
extension to pin 3 of P6007 and paralled the CW-N and CW chassis wires. An
easily reversable change.
Now when I select cw the 2.0 KHz filter is always enabled.
I do want wide band-width on the sub-receiver so I can locate the station
the DX is working while split.
de Paul, W8AEF
ZF2JI/ZF2TA FO8DX/FO8PLA 8Q7AA XZ0A VU7RG TX5C
----- Original Message -----
To: "Paul Playford" <email@example.com>
Cc: "John Ahlbom" <firstname.lastname@example.org>; <email@example.com>
Sent: Wednesday, October 14, 2009 12:01 PM
Subject: Re: [Yaesu] FT-1000 vs. FT-1000D
> That is absolutely right. When I first got my 1000D, I thought the sub-RX
> was gone because I had the 500 Hz filter selected. You can get a 600 Hz
> filter for the sub-RX, but since I have two FT-1000s set up for SO2R, I
> rarely use the sub-RX.
> Rob K6RB
Yaesu mailing list