[TowerTalk] Aligning rotators (was: Thrust Bearing)

[Bill Coleman <aa4lr@arrl.net>]

On Jul 22, 2004, at 3:46 PM, Chuck Lewis wrote:

> Only if everything were exactly collinear, balanced and plumb, with no 
> wind,
> would the mast not touch any of the bolts. That's the whole point, and 
> the
> issue to which my post responded: elimination of potential binding from
> misalignment.

Is it really so hard to get the thrust bearing in alignment with the 
rotator?

When I put up my tower with a pointy top, I did some ground work to 
achieve alignment. I temporarily mounted the top section at ground 
level. Then I placed the mast in the top section, then the rotator the 
end of the mast, then the attached the rotator shelf to the rotator, 
then the shelf to the tower.

In this way, the shelf is aligned at the right angle so the rotator 
axis is the same as the collar.

Result - no binding.

Bill Coleman, AA4LR, PP-ASEL        Mail: aa4lr@arrl.net
Quote: "Not within a thousand years will man ever fly!"
            -- Wilbur Wright, 1901

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk