OK now we are getting to the question I have been wanting to ask. Can a rebar
cage work just as well if it is cut and welded together rather than bent and
wire tied? It is my plan but thought I might toss the idea out for the critics.
Phil
N9LAH
-------------- Original message --------------
From: Robert Hess <w1rh@yahoo.com>
> Just built the cages for my Rohn 45 guy anchors.
> First time for me. Quite a learning process. These
> cages are only 2.5/2.5/1.5 and I could not make it
> work by bending the re-bar. Cut each piece. Adding
> diagonals made a hell of a difference. I also used
> multiple ties on each junction plus lots of extra
> re-bar pieces. Now they are quite sturdy and ready to
> be set in place.
>
> Bob
> W1RH
> --- Larry Burke wrote:
>
> >
> > Are there any tricks of the trade when it comes to
> > making sturdy rebar
> > cages? I have used tie wires, along with the tie
> > wire tool, but mine tend to
> > flop around when complete. Could I be tying the
> > wires incorrectly? I realize
> > it doesn't make a whole lot of difference once the
> > concrete is poured, but
> > I'd like to understand how to give these a more
> > professional look and feel.
> >
> > On a somewhat related issue, an area Lowe's store is
> > now stocking a ground
> > clamp designed specifically for use on rebar. First
> > time I have seen these
> > at a big box store. They look similar to the type
> > that clamps on a water
> > pipe, but the clamp is designed to grab a smaller
> > diameter "pipe" (the
> > rebar) and accommodate a slightly larger ground
> > wire. Useful for anyone
> > planning a UFER ground, although I suspect a
> > exothermic weld connection
> > would be better.
> >
> >
> > Larry Burke WI5A
> >
> >
> >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> >
> http://lists.contesting.com/mailman/listinfo/towertalk
> >
>
>
>
>
> ________________________________________________________________________________
>
> ____
> Shape Yahoo! in your own image. Join our Network Research Panel today!
> http://surveylink.yahoo.com/gmrs/yahoo_panel_invite.asp?a=7
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|