Place a generous drop of RTV on the end of the Phillystran, then install the
cap. Rotate the cap a little to make sure the RTV is spread internally to the
cap.
I use caps on my 6700i Phillystran and they were a snug fit before the RTV.
YMMV.
Kim K5TU
On Oct 26, 2015 9:57 AM, GMuller885--- via TowerTalk <towertalk@contesting.com>
wrote:
>
> Well folks I am back.
> I have now applied my Phillystran to the boom truss and the foe and
> aft guys and clamped them as suggested. I also purchased Vinyl End Caps for
> the correct size Phillystran. When I went to install the end caps they were
> very loose. What is the CORRECT way to put the end caps on the Phillystran?
>
> Gerald Muller K9GEM
> GMuller885@aol.com
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|