How about omitting the linear loading and converting it to loading coils,
which is probably a better option anyway. My High-Q coil loaded 40m beams
are not resonant on 15m, one is about 17 feet away from my middle 15m beam
with no noticeable interaction.
John Kk9A
To: "tower" <[email protected]>
Subject: [TowerTalk] how does one accomplish a 'stud' for elements?
From: "StellarCAT" <[email protected]>
Date: Sat, 2 Jan 2016 09:04:51 -0500
Specifically adding something to a 4 element 40 to eliminate 15 meter
interaction? I believe Optibeam does this ? not sure how they do it. Is this
just using the element with a parallel line tuned through a cap for max
current
on 15? If so any suggestions on how long to make it and where specifically to
put it on each element 1/2?
Or is there a way to use a relay, open normally, closed when on 15 that would
add some impedance to the antenna causing it to be detuned at 15?
Alternatively I can rotate the antenna 90 degrees but boy it would be so much
better not to have to do that to avoid interaction on 15.
thanks in advance,
Gary
K9RX
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|