Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tower location and house noise

To: RLVZ@aol.com, towertalk@contesting.com
Subject: Re: [TowerTalk] Tower location and house noise
From: Grant Saviers <grants2@pacbell.net>
Date: Tue, 23 May 2017 02:12:45 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Adding a few thoughts to what others have said, and based on some anecdotal experience: My towers are 50' to 110' from the shack and located for what I could do within lot constraints for minimizing pattern overlap for Asia and EU azimuths from my WWA QTH. For a suburban location I think I hear fairly well, often better than my QRO talks, probably because of noise at the other end, unless I encounter a TV, switcher, or power line QRM at times. But a lower noise floor is always better.

I bury all coax and control lines. They make good antennas if elevated and chokes aren't 100%.

And use at least double shielded (premium foil plus braid) coax or hardline. Only hardline approaches 100% shielding.

Likewise, I now mostly use DIN's. There is a lot to be learned from the cell business re connectors, grounding, waterproofing, and PIM.

If possible, I run coax and control lines inside the tower, it is a free Faraday shield. My crankup with the 9917 coax hanging outside in the air is noisier than the fixed tower with the hardline coax all inside.

Control lines that go near antennas can be a source of noise. My soon project is to filter/choke my SteppIR control lines with that in mind.

I prefer antennas with minor high angle lobes at the height I install them. I think it is better to sacrifice a db of gain for a better pattern. I've modeled a 6L 17m extensively and the "handbook" design can be substantially improved in this regard.

A walk about with my PL660 Tecsun radio was informative about noise sources to be tamed.

I'm also adding a loop receive antenna for sharp nulls of point noise sources.

Grant KZ1W







On 5/22/2017 17:06 PM, RLVZ--- via TowerTalk wrote:
Guys,
I'm wondering if some of you locate your tower(s) away from the shack for
the single purpose of minimizing man made  noises?  I have K9YC's material
on reducing man made noises but I  haven't had a lot of success.  I'll soon
be constructing a new  tower and am wondering if it's worth placing the tower
a 100' from the  shack in hopes of reducing man made noises?
Thanks & 73, Dick- K9OM
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>