Re: [TowerTalk] Clamp on ground resistance meter

[Wes <wes_n7ws@triconet.org>]

Hmmm.. Every other reference I see about using one of these says that a loop is 
required.

On 10/2/2019 11:00 AM, Bryan Fields wrote:
> On 9/29/19 2:51 PM, Julio Peralta via TowerTalk wrote:
> > Does anyone have any experience using a clamp on ground resistance meter?
> Yes, they work well.
> > I bought one to use to help with my grounding project but don't have any
> > experience using this type of meter. Any advice would be appreciated.
> Ensure it's calibrated every time you use it.  You should ensure it's not
> measuring a loop, that will give errors.  Single point or off a master ground
> bar feed is the right place to measure it.
>
> I have this model:https://www.amazon.com/gp/product/B01N7FSF6N
>
> Was a steal for 300 dollars.  I've used it at my home and numerous sites to
> ensure the building ground is sufficient.
>
> 73's

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk