Doesn't that result in the two guys crossing each other?
AA4GA
On Thu, Oct 13, 2022 at 3:55 PM <john@kk9a.com> wrote:
> I am not a mechanical engineer but what I do is move the lower anchor
> further out (~3' in your case) and move the higher one closer to the tower
> in an attempt to maintain the guy wire angle at the tower. The angle will
> still vary slightly at the lower guy height(s) but it should work fine,
> even
> with multiple rotating beams mounted along the tower.
>
> GL
> John KK9A
>
> Lee Hiers AA4GA wrote:
>
> Hi All,
>
> I'm putting a tower in a field at my QTH, and the field is terraced a bit.
> One guy anchor will be at the same level as the base, and one about three
> feet above that level and another about three feet below.
>
> The tower is 80' of Rohn 55G, and I'll be guying at 80' and 40'. For the
> anchor at the same level as the base, I'll go out 80% - ~64'. What do I do
> for the uphill and downhill anchors?
>
> Eventually I may have a side-mounted TH7 at the 40' level, FWIW.
>
> 73 de Lee, AA4GA
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|