Amps
[Top] [All Lists]

Re: [Amps] Question about safety ground connection

To: "Gary Schafer" <garyschafer@comcast.net>
Subject: Re: [Amps] Question about safety ground connection
From: R.Measures <r@somis.org>
Date: Wed, 16 Nov 2005 02:53:04 -0800
List-post: <mailto:amps@contesting.com>
On Nov 15, 2005, at 7:11 PM, Gary Schafer wrote:

> It doesn't matter which wire you use as hot and which one is switched 
> when
> connected to a switch. I have a wiring book that has two different 
> examples.
> One way white is hot to the switch and the other example black is hot 
> to the
> switch.
>
> You should always mark a white wire that is used as hot with black 
> tape at
> both ends to identify it as a hot wire.

Unless it's a 240v circuit, and in that case, the 2 hot wires should be 
marked black and red at both ends.

> It is also common practice to come into the bottom of the switch with 
> the
> always hot wire and go out the top of the switch with the switched 
> wire.
>
> 73
> Gary  K4FMX
>
>> -----Original Message-----
>> From: amps-bounces@contesting.com 
>> [mailto:amps-bounces@contesting.com] On
>> Behalf Of Will Matney
>> Sent: Tuesday, November 15, 2005 7:35 PM
>> To: amps@contesting.com
>> Subject: Re: [Amps] Question about safety ground connection
>>
>> In a switch leg using say 12-2 or 14-2 romex, the white wire is hot 
>> at the
>> switch. The white and black tie together in the junction box of the 
>> light
>> fixture, and the black off the switch goes to the black wire on the 
>> lamp.
>> So yes, this is a case where the white is hot. The NEC only allows 
>> this
>> case too.
>>
>> Best,
>>
>> Will
>>
>> *********** REPLY SEPARATOR  ***********
>>
>> On 11/15/05 at 8:24 PM Gudguyham@aol.com wrote:
>>
>>> In a message dated 11/15/2005 1:20:38 P.M. Eastern Standard Time,
>>> craxd1@verizon.net writes:
>>>
>>> I always  want to know a neutral isn't hot unless it's going to a 
>>> switch
>>> leg
>>> which I  think is the only NEC exception to the  rule.
>>>
>>> Best,
>>>
>>> Will
>>>
>>>
>>>
>>> If a "white" wire is hot, it is not a neutral.  So a neutral is never
>> hot
>>> unless there is a fault.
>>> _______________________________________________
>>> Amps mailing list
>>> Amps@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>

Richard L. Measures, AG6K, 805.386.3734.  www.somis.org

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>