TenTec
[Top] [All Lists]

RE: [TenTec] TT 526 '6n2' Lockups

To: <tentec@contesting.com>
Subject: RE: [TenTec] TT 526 '6n2' Lockups
From: "Cliff KD4GT" <kd4gt@bellsouth.net>
Reply-to: kd4gt@bellsouth.net, tentec@contesting.com
Date: Sat, 26 Jun 2004 03:35:56 -0000
List-post: <mailto:tentec@contesting.com>
Uh huh. That darn thing will get stupid on occasion although yours sounds
like its happening far more than normal. The one (first) glitch I heard on
one was that it seemed fine on the Rx but was sounding like it was off freq
by 2+KHz on a repeater. The user also noticed the power out was dropping.
The "mash a button while powering on" master reset put everything back to
normal. Of course any memories you had are now past tense!!! Too bad this
rig was pre- download a new micro-code era.

> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Duane A Calvin
> Sent: Friday, June 25, 2004 19:29
> To: tentec@contesting.com
> Subject: [TenTec] TT 526 '6n2' Lockups
>
>
> For those of you with one of these rigs, have you ever had it lock up or
> seem to go into oscillation?  The one I recently purchased at swapmeet
> worked fine for 4-5 hours, then, when I hit the V/M button after sitting
> in RX for a while, it lost its mind.  First it completely locked up -
> master reset or power cycles were no help.  After a few hours of rest, I
> repowered it and it was back to working fine.  Last night I fired it up
> again, and it would not transmit, nor tune.  Strange symptoms.  I'll be
> opening it this weekend, but thought if anyone had seen this kind of
> behavior before, it might offer a starting place.
>
>         73,  Duane
>
>
> Duane Calvin, AC5AA
> Austin, Texas
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>