| To: | "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Noise Reduction Setting |
| From: | "Grant Youngman" <nq5t@tx.rr.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 4 Dec 2006 20:09:04 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
> If you gentlemen come up with a set of control parameters > that allow the use of DSP NR with CW, please post your solution. If you operate CW with reasonably narrow bandwidths, DSP NR is largely superfluous, if not downright useless. The most effective noise reduction tool in CW mode (any radio, not just the Orion/II) is the the bandwidth control. I know that's not the answer you're looking for, but it is the case. There's considerable discussion in the reflector archives on the subject. Grant/NQ5T _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] [orion565] Astron Power Supplies, Chuck Frame |
|---|---|
| Next by Date: | Re: [TenTec] Noise Reduction Setting, Chas Nagel |
| Previous by Thread: | [TenTec] Noise Reduction Setting, Emil Borys |
| Next by Thread: | Re: [TenTec] Noise Reduction Setting, Barry Gross |
| Indexes: | [Date] [Thread] [Top] [All Lists] |