TenTec
[Top] [All Lists]

Re: [TenTec] Headphones for ORION I?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Headphones for ORION I?
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 12 Aug 2010 21:14:51 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I use 12 band graphic equalizer to filter out the highs and lows and
thus they don't bother me.   It really helps clarify old time radio 
programs, which are mostly speech, anyway.    I sometimes use a Timewave 
DSP 599zx audio filter, and when I am not using the DSP to kill some 
noise, I use its high cut and low cut filters in the same way as the 
audio equalizer.   That allows me to use high end earphones, and still 
not be bothered by unwanted noise outside the human speech frequency band.

My Sennheiser HMD-45-6 headset has a limited earphone response curve to 
address this point -  they only play between 100 Hz and 5,000 Hz,  so 
that means they act as if they have a built in high cut noise filter. 
The microphone get great reports, also.

Similarly, my Shure SM-2 headset has earphone receivers which are 
limited to only 100 - 8000 Hz.    The product guide says:

                The dual earphones have a frequency response of 100 to
                8,000 Hz with excellent voice intelligibility for cue, program,
                sidetone, or intercom signals. High sensitivity and the enclosed
                ear feature help to block out room noise and ensure
                clarity of the incoming signal.

THESE ARE EXCELLENT FOR HAM RADIO AND I USE THEM OFTEN ON MY OMNI VII 
and  the rig and microphone work together wonderfully.   I get lots of 
good audio reports on that microphone.

The limited earphone receiver frequency response addresses the point 
about not wanting to hear high frequencies if there is only noise up there.

Just MY take, anyway...

===================  K8JHR  ====================================



> On 8/12/2010 3:46 PM, Stuart Rohre wrote:

  .  He reports operators get tired
>> listening to any audio above the voice or SSB, needed frequencies.
>> In fact, you may want to put a band limiting filter in front of any hi
>> fi headphones to avoid operator fatigue if you do much DX operating.
>>
=================================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>