Hello Jim:
As you reported - W3LPL and K3LR (and many others) are using this method
with the Amphenol 83-1SP of soldering the shield on the back of the
connector. It works great.
http://www.k3lr.com/engineering/pl259/
No melted dielectric and very visible great soldered connection of the
shield. No failures here at the K3LR multi multi station in over 30 years -
and the contest station success efforts - show good results.
Hope to see you in Dayton
73
Tim K3LR
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Jim
Brown
Sent: Tuesday, May 10, 2016 8:05 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] PL259 Connectors Part 2
On Tue,5/10/2016 4:48 PM, Kevin Stover wrote:
> I tried to pull one off a waste piece of coax. Connector clamped in my
> bench vise and two guys pulling on the coax.
> Didn't budge. Try that with the soldered connector.
A properly installed soldered Amphenol 83-1SP makes a pretty strong
connection to the coax. "Properly installed" includes stripping just
enough braid so that it shows through the solder holes and so that the
coax jacket screws into the connector shell, soldering the braid at each
hole so that it flows well, and doing a good soldering job on the center
conductor. Many times, I've had to yank pretty hard on the RG11 attached
to high dipoles to guide them away from tree limbs, etc. So far, I've
never had one pull apart.
K3LR has developed a method of soldering the braid to the OUTSIDE of the
connector shell and covering it with heat shrink. That's probably even
stronger! I've done that with a few connectors, but wasn't thrilled
with the result. QST published it a few years ago, and I think it's
somewhere on the internet.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|