Amps
[Top] [All Lists]

Re: [Amps] Cal Lab

To: <craxd1@verizon.net>, <amps@contesting.com>
Subject: Re: [Amps] Cal Lab
From: "Gary Schafer" <garyschafer@comcast.net>
Reply-to: garyschafer@comcast.net
Date: Sun, 23 Apr 2006 19:17:10 -0400
List-post: <mailto:amps@contesting.com>
If you use the tv be sure to check with the station to see if they actually
use a rubidium or other good standard. I don't know about these days but in
the past not all stations used good standards.

73
Gary  K4FMX

> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
> Behalf Of Will Matney
> Sent: Sunday, April 23, 2006 3:07 PM
> To: amps@contesting.com
> Subject: Re: [Amps] Cal Lab
> 
> Bob,
> 
> You know I never did think of that, but your exactly right! A person could
> make a circuit up to do that using a color burst crystal and connecting to
> the cable, but that would be a good size project. Using a small, cheap TV
> with a jack on the back, picking up the color burst signal would be the
> cheapest way.
> 
> I actually have two OCXO's in two pieces of equipment I already have. I
> have a HP 5328 counter with an internal 10 MHz OCXO standard, and a Racal-
> Dana RF generator with an internal OCXO standard. The one I'm building is
> using a HP 10 MHz OCXO from a counter that was calibrated the other day.
> The standard has the OCXO, a power supply, and a buffer amp in the
> cabinet. Not hard to build at all. The rubidium one I'm going to build is
> the same setup. You can buy the rubidium modules off ebay at a good price.
> All they really need is a power source, and a buffer amp as an option.
> There's a guy selling the kits on ebay to build a GPS disciplined OCXO
> too. He has both the kit and the OCXO's for sell which together cost about
> $150. I could buy the kit for $75 and finish it. I may do that on another
> project, or modify this one later on. The 10 MHz OCXO I'm getting, I want
> to use to check my counters and generators with first thing where it has
> been calibrated. I was looking at one simil
>  ar built by a ham on the net showing in detailed photos what he did. He
> built a box inside the chassis for the OCXO, and lined it with styrofoam
> insulation. He said it helped stabilize it tremendously from room
> temperature fluctuations. The rest he did the same as me, using a
> regulated PS, and a buffer amp.
> 
> Best,
> 
> Will
> 
> 
> 
> >*********** REPLY SEPARATOR ***********
> >
> >On 4/23/06 at 2:37 PM BIRCHWAY@aol.com wrote:
> >Will:
> >If you need a quick and easy source for accurate frequency, you can run a
> >probe from your freq. counter to the back of a color tv set and pick up
> >the 3.58 color burst signal, which is phase locked to WWV
> >nationwide...Bob...W0PQX....
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>