Don't think so Phil,
I had these made as they saved me cutting the chassis by hand, and drilling
the holes etc..
Andy
http://gd0tep.com
-----Original Message-----
From: Phil Clements [mailto:philc@texascellnet.com]
Sent: 03 April 2008 17:31
To: 'Norman Hockler'; andy@gd0tep.com; amps@contesting.com
Subject: RE: [Amps] YC-156 grid ring
I just bolt my YC-156's directly to the chassis. Did I make a boo boo???
Phil, K5PC
Subject: Re: [Amps] YC-156 grid ring
Do you mean "mounting plates"
N8NH
At 07:20 PM 4/2/2008, Andy GD0TEP wrote:
>Hi group,
>
>I recently had some aluminium grid rings laser cut for the YC-156. As there
>was a minium order, I now have some pare.
>
>They are on ebay if anyone is interested. Item number: 330225029167
>
>Cheers,
>
>Andy
>http://gd0tep.com
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|