Gentlemen,
If I'm not wrong, on the glass tube, there is only an incremental benefit to
the air circulation - the anode dissipation happens primarily by radiation,
not conduction, and I think that means that little of that radiation is
absorbed by the glass.
Air circulation does help to keep the pins, cap and envelope from
desoldering, but it does little to improve the anode dissipation capability
as is the case with a metal variety. And I don't think that the plate cap
is very effective as a disipation mechanism because the thermal resistance
of the anode lead has got to be high.
So the caution should be - yes, air is good. Very good. But if you are
heating the anode to a temp beyond it's specification, the degragation in
the condition of the anode is going to be happening no matter how much air
is blowing over the envelope.
73/jeff/ac0c
www.ac0c.com
--------------------------------------------------
From: "k7fm" <k7fm@teleport.com>
Sent: Monday, August 16, 2010 9:08 AM
To: "Rudy Bakalov" <r_bakalov@yahoo.com>; <amps@contesting.com>
Subject: Re: [Amps] Can I cool too much the tubes?
> Is there a risk of running the tubes too cool if I have a much higher air
> flow?
>
>
> You would suck (or blow) the tubes out of their socket before you cooled
> them too much.
>
> Air is your friend. Plenty of air is your better friend.
>
> 73, Colin K7FM
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|