yes, HV filter choke. The RF choke would not work well in the ground lead.
;-).
jeff, wa1hco
On Fri, Sep 27, 2019 at 6:02 PM Jim <jimw7ry@gmail.com> wrote:
> Unless you mean the plate supply filter choke? Not the plate choke that
> connects to the tops of the tubes?
>
>
> Thanks
> 73
> Jim W7RY
>
> On 9/27/2019 5:00 PM, Jim wrote:
> > Can you please draw me a diagram of the*plate choke *in the ground
> > lead please?
> > Thanks
> > 73
> > Jim W7RY
> > On 9/26/2019 9:59 PM, Ron wrote:
> >> Jeff wa1hco millar wrote:
> >>
> >>> Hello wise ones...
> >>
> >>> Bought a nice 3K-A at a flea market and made one SSB contact. On the
> >>> second contact it tripped off on HV overcurrent. After some
> >>> debugging, the
> >>> Plate choke is leaky to ground at HV but open with an Ohm meter.
> >>> Can I just put the choke up on insulated standoffs?
> >>
> >>> Any other suggestions?
> >>
> >> It is a pleasure to be helpful.
> >>
> >> The CURE is to put it in the ground side of the circuit, typically
> >> where the rectifier or the grounded side of the transformer goes to
> >> ground.
> >>
> >
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|