[Karlnet] Simple Plastic Backplates

["Nate McLain" <nate@ctrail.net>]

Are there any plans for KN to sell a simple plastic backplate for the new
boards that are shipping?
It would be nice to be able to have them made out of plastic and have the
ability to isolate the board with the plastic backplate.
Maybe using the same type of setup that was on the RG cases.
That would allow for access to the compact flash socket when you need to get
to it.
I would think that these could be produced by a injector molding shop in
mass quantities at a very cheap price.

Are there any plans for something like this??


Nate